Safe Systems Deadman Control Switch (Electric) Repair Kit

Control Switch (Electric) Repair-Kit is the repair kit for our (50-120) Safe Systems Deadman Control Switch (Electric). Everything you need to bring this deadman switch back to life!

Control Switch (Electric) Repair-Kit Instructions

• Remove back plate on the Deadman switch body by removing four (4) phillips head screws.  You can see the back of the switch.
• Loosen strain relief curly item only.  This allows the wire to move freely.
• Unscrew rubber trigger boot that is located around the “bat” of the switch.
• Remove wire spade connections at the back of the switch from the switch.  Remember where the spade connectors go on the switch.
• Remove hex nut holding the switch to the deadman switch body.
• Remove switch from the deadman switch body and replace with a new one.
• Screw on the new hex nut to the newly installed switch.
• Reattach the wire spade connections at the back of the switch from the switch.
• Screw on the new rubber trigger boot around the “bat” of the new switch.
• Replace the gasket around the back plate.
• Reinstall the back plate with new phillips head screws.

OEM:

• Safe Systems 6911-0020

Blue Dog Blasting SKU:

• 50-123

Visit Rodeco.com for the best deals on Abrasive Media! Tell them the Blue Dog Sent you!